- X800e sony firmware update install#
- X800e sony firmware update update#
- X800e sony firmware update windows 8#
Turn off the camera, remove the battery pack, reinsert the battery and turn on the camera. According to the message, stop the USB connection and click Finish.
X800e sony firmware update update#
If the screen on Figure 4 appears, the update is not required.
After confirming Current Version is Ver.2.00, click. The current version and the version after the update appear on the lower left part of the screen. After confirming the screens on Figures 1 and 2, click. Note: From now on, never turn off the camera until the firmware update is completed. Figure 1 appears on the Firmware Updater window, and Figure 2 appears on the LCD screen of the camera. After confirming the above, click Next on the Firmware Updater window. Confirm the "Safely Remove Hardware" icon is displayed on the task tray at the lower right corner of the computer screen. In this case, remove the battery pack from the camera, reboot the computer, and follow the procedures from "2. Sometimes when the camera is connected to the computer with the USB cable, the message to encourage rebooting the computer may appear on the computer display. Your computer may have some USB terminals on the backside. If the computer has multiple USB terminals, try with the other terminals. Disconnect the USB cable and connect it again. If the computer cannot find the camera, the message " Could not find the camera for this update." appears on the computer display. When the camera is connected to the computer, the LCD screen of the camera turns off. Connect the camera to the computer with the supplied USB cable. Remove the memory card from the camera beforehand. If another mode than is selected, select. Turn on the camera According to the instruction on the Firmware Updater window, select - on the camera, and check if Mass Storage is selected. Double-click the file you downloaded to start up the Firmware Updater. Close all currently running programs on your computer. X800e sony firmware update install#
Once the file has downloaded successfully, you're ready to install the Firmware update Ver.3.00 for HDR-CX900E. Click the tile from the Start screen and find the download file in the folder by using Explorer.
X800e sony firmware update windows 8#
For Windows 8 users: Under the initial settings of Internet Explorer, the update file will be saved in the folder.
Save the file to the desktop of your computer (recommended). At the bottom of the page, read the disclaimer and agree to the terms and conditions by clicking on the checkbox. Make sure that you are logged on as a user with administrative rights. In case the computer would go into sleeping mode and the update would be interrupted, redo the complete update process from the start. The firmware update takes approximately 15 minutes, therefore prevent your computer from going into sleeping mode. Do not remove the battery during the update otherwise, the camera may become inoperable due to the sudden power shutdown. When performing the firmware update, please use a fully charged rechargeable battery pack NP-FV50 or the AC Adaptor.
0 kommentar(er)
